Power Cable With Plug

Twisted pair cables such as CAT5, CAT5e, CAT6 and CAT6a cable are a low cost and easy installation alternative to traditional coax cables for transmitting KVM and AV signals.   KVM (keyboard-video-mouse) extenders via CAT5 may be used to remove computers from harsh or sensitive environments, or to restrict physical access to the computer. Video extension products such as VGA, DVI, S-Video or HDTV extenders via CAT5 are used to extend video displays. Each extender consists of two units - the local and remote units, which are interconnected using a CAT5/5e/6 cable.This article focuses on the proper method for terminating a CAT6 shielded solid or stranded cable using standard tools and materials that are readily available.  

With the proper use of the tools and a little practice you will be terminating CAT6 cables in no time.Prepare the cableYou will first need CAT6 shielded cable (solid or stranded for the purposes of this article) cut to the desired length.  The cable can be terminated before or China 3 Way Power Strip suppliers after installation, even if you have a long run to make.  Using a cable tester from VPI (www.vpi.us) the cable can be easily tested for continuity, crossed pairs and pinouts to make sure all connections have been made properly. Next you will need to make sure you have the correct plugs to terminate the cable with.  

Different plugs are intended to different types of cable, whether you have solid or stranded connectors, flat or round cable, shielded or unshielded, and CAT5, 5e, 6, or 6a.   Be sure to use a plug suitable for your cable. For tools you need a CAT5 wire stripper, wire cutters, RJ45 crimp tool (specially designed for RJ45 plug with cable clip), and a CAT5 cable tester. Terminate the cableFirst, slide the plug boot onto the cable, being sure to orient the boot such that the open side is towards the cut end of the cable.   Then carefully strip the jacketing from the cable to expose 1" of the insulated wire conductors and shield. Don’t cut too deeply or you will knick the shield and wire insulation underneath.  If you just score the cable jacket and bend the wire in several directions to finish the break, the result will be a good problem-free cut. Next, peel the foil shield insulation back onto the cable jacket and trim to within approximately ¼” of the jacket edge. Wrap the drain wire such that it is located at the bottom (locking-tab side) of the cable.